ORTUR LU2-10A
Cutting in One Pass
10mm Wood Cutting in One-PASS
Pine Board, Maximum Cutting Thickness 20mm
8mm Acrylic Cutting in One-PASS
Acrylic Sheet, Maximum Cutting Thickness 30mm
Observe LU2-10A in 360 degrees.
Engraving Speed up to 15,000mm/min
More Precise Cutting & Engraving
Stable & Lighter 10W Laser Module
Air Assist
Higher Precision
LU2-10A
Package Lists
Customer Reviews
Based on 2 reviews
50%
(1)
50%
(1)
0%
(0)
0%
(0)
0%
(0)
M
Best👍👌
A
Upgraded my LM2Pro without any issue. So far I've cut through 5/8" (26mm) softwood, 1/2" (13mm) plywood and hardwood. I'm using a honeycomb bed and new air assist. Only slight discoloration on the surfaces. My only complaint is the cheap air hose. The way it was packed it ended up having a lot of 180-degree bends which caused the sticky rubber to close up on itself. I had to stretch out and open up all the bends. I don’t think it has affected the air flow, however, I’m not sure. A higher quality air hose would have been much better.
